How Simple To Remove A Factory Car Audio
The car audio business is thriving. New models of car stereos are being released almost monthly, and it’s no surprise, being that many people spend a good deal of the day in their vehicle driving to work or running errands. Whether you decide to upgrade your stereo system or have a vehicle with a broken stereo, removing a factory car stereo is relatively easy. Be sure to follow the following steps carefully and the deviation are to be avoided.
You will be requiring the following tools to remove the Factory car stereo. This includes Screwdriver set, a quarter inch drive socket and ratchet set .
In the first step the reveal-molding in the front of the dash is removed.
of appropriate size to be used and turned counter clockwise till the screw comes out of the holes. Once the screws are taken out, dash plate is removed and kept aside.
Using a common screw driver remove the cover out. To keep the dash covers on there are snaps that snap into a hole. But if the fuses are on the drivers side then look for the screw which may be inside the cover. The dash cover will be held by these screws. the dash covers are held just by the snaps and screws.
Grasp the antenna wire by placing your hand behind the stereo. The antenna wire is the one which will be a black wire and will be of approximately 1/4 inch in diameter. The location of the antenna wire will vary according to each vehicle. Then, the stereo has to be hold using the other hand. Once holding the stereo, pull the antenna wire firmly to disconnect it.
The face plate is installed on the front of the radio and the tangs are bent so as to hold the face plate in the positon. Put all the screws and install all the dash covers as such as how it was before.
After disconnecting the power the speaker wires are to be disconnected. There will be two speaker wire plugs namely front and back speaker wires which will look one and the same. You will then find the remaining two plugs which are to be disconnected in order to remove the stereo from the place. In order to do this, each side of a plug has to be grasped, squeezed and then pulled at the same time to disconnect them. This process has to be repeated with both plugs following the above procedure. Once all the plugs of the stereo are disconnected, the stereo has to be grasped with your hands and then pull it out of the hole completely. By following the above said steps, you can do a professional job removing a factory car stereo your door steps without spending a penny.
Want to find out more about Car Hifi, then visit Author Name’s site on how to choose the best Car Audio for your needs.
